Set of 15 Holographic Stickers & 1 Glow-in-the-Dark Sticker - For Making Metal Jigs and Lures

A, Magma x 5 sheets
B, Stripe x 5 sheets
C, Dot (Sand) x 5 sheets
D, Glow x 1 sheet

Total 16 sheets.
(Hologram sheets come in sets of 5, and Glow is 1 sheet.)
Size is 10cm x 20cm.

■ About Pattern Changes

You can choose your preferred patterns, so please contact us via comments on the listing page or through transaction messages. Please request a total of 4 sets from A to D as follows.

Example: 3 sets of A, 1 set of D (In this case, we will send you 15 sheets of A and 1 sheet of D.)
Example: 1 set of A, 1 set of B, 2 sets of C (In this case, we will send you 5 sheets of A, 5 sheets of B, and 10 sheets of C.)
Example: 4 sets of D (In this case, we will send you 4 Glow sheets.)

Note: It is not possible to divide a set of 5 sheets into 2 and 3 sheets.

If there is no specific contact from you, we will send you the total of 16 sheets with the basic combination as described above.

If you do not understand the explanation above, please feel free to ask questions in the comments.

■ Pattern Details
You can easily make Zebra Glow yourself!
You can apply it in one go to a 20cm long jig without it tearing in the middle.
We recommend this to those who regularly use Axel or Zesta sheets.

A, Magma pattern is a classic pattern often seen on slow-style jigs.

B, Stripe pattern is common on seabass minnows and bluefish jigs.

C, I personally believe the sand pattern resembles sardine scales.

D, Glow sheets are expensive to produce and are priced higher than the other 5 hologram sheets. However, we have selected ones with very high luminescence.

* As an example of using glow sheets, we have added photos of them applied to commercially available lures.
(The eyes and holograms on the lures themselves are from the original products.)
If you improve your crafting precision, you can also make manufacturer-quality lures yourself.

■ Frequently Asked Questions
Q) Do the sheets stretch?
A) They do not stretch when pulled.
When applying to curved surfaces, start applying from the center and push out any air bubbles towards the edges.

Q) Are these transfer sheets?
A) They are stickers with an adhesive backing.

Q) Can I use them as is after applying?
A) After applying, please coat them. Dipping them in urethane floor coating will give a beautiful and thick finish, but you can also coat them with 100-yen shop epoxy adhesive. Also, on flat surfaces with minimal damage, such as the sides of a Tai Rubber, they are less likely to peel off even without coating. (Seller's experience)